MOTOKOMPASS Tool for Circular Cuts and Bullnose by Raimondi

MOTOKOMPASS is a device designed to create rounded or rounded corner furnishing elements. Diameters you can perform: minimum 30 cm, maximum 100 cm. You can perform half/bullnose and 45° miter (jolly) profiles. Half/bullnose profiles can be performed on slabs and tiles with a thickness from 5 to 12 mm. Raimondi Bullnose blades are available in 1/4" (6mm) Radius, 3/8" (10mm) Radius and 1/2" (12mm) Radius, to fit 5" angle grinders. Available radius: 6 mm, 10 mm, and 12 mm. 45° miter (jolly) profiles can be performed on slabs and tiles with a thickness from 3 to 12 mm. For finishing/polishing the shaped edges, it is recommended to use an angle grinder freehand (max 1400 rpm) with diamond pads. It can be used either dry (with a dust extractor) or with water (with a kit for wet cut art.433PWW A). Suitable with almost all 5" angle grinders with power between 600-1100W. Available for grinders with M14 arbor attachment (Art. 433KOMOHR) and for angle grinders with 5/8“ - 11 arbor attachment (Art. 433KOMOHUS). Equipped with: “RV 175” vacuum pump suction cup with a vacuum gauge for use on textured surfaces (special references on the suction cup are available to correctly position the suction cup to the work to be performed), a scoring device with diamond wheel Ø 16mm, a housing unit for an angle grinder for shaping edges, cutting-off plier for a snap after the scoring cut, use and maintenance manual. Angle grinder and diamond tools are not included: they have to be purchased separately